Not FoundStep one is to drill a ¼ hole 1 ½" deep in the top center of the bun foot. It is important that the hole is drilled straight up and down so that the metal part will be at a 90 degree angle to the top surface of the bun foot.
Not FoundAfter the hole is drilled the use of a tool called a vise grip is helpful in grasping the screw dowel.
Not FoundThe screw dowel simply is screwed into the top of the bun foot as demonstrated. The procedure is finished when half of the screw dowel\'s length is in the bun foot.
Not FoundOnce this step is complete drill a 3/8" hole in the bottom of your piece 1 ½" deep then hand screw your entire bun foot into the bottom of the piece.